Buderus 600 - 11R Installation And Servicing Instructions page 39

4. Adjust room and cylinder thermostats and
programmer to NORMAL settings.
2.2.12 Handing over
After completing the installation and commissioning of
the system the installer should hand over to the
householder by the following actions:
Hand the User Manual to the householder and
explain his/her responsibilities under the relevant
regulations.
Explain and demonstrate the lighting and shut down
procedures.
The operation of the boiler and the use and adjust-
ment of all system controls should be fully explained
to the householder, to ensure the greatest possible
fuel economy consistent with the household require-
ments of heating. Advise the user of the precautions
necessary to prevent damage to the system and to
the building in the event of the system remaining
inoperative during frosty conditions.
Explain the function and the use of the boiler heating
controls.
Explain the function of the boiler fault mode. Empha-
sise that if a fault is indicated, the boiler should be
turned off and a registered local heating installer
consulted.
Explain and demonstrate the function of time and
temperature controls, radiator valves etc., for the
economic use of the system.
Loss of system water pressure
Explain that when there is a significant loss of pres-
sure the user should contact a Corgi registered
installer.
WARNING!
Do not fire the boiler if the pressure has
reduced to zero from the original setting.
WARNING!
After installation, commissioning and customer
handover instructions please complete the BENCH-
MARK appliance log book and leave this with the
customer.
Subject to modifications resulting from technical improvements!
Installation and servicing instructions for wall-mounted condensing gas boiler Buderus 600 - 11R/19R/24R • 02/2006
Commissioning
Buderus • http://www.buderus-domestic.co.uk
2
39