Buderus 600 - 11R Installation And Servicing Instructions page 22

1 Installation
The air inlet/products outlet duct and the terminal of the
boiler MUST NOT be closer than 25 mm to combustible
material. Detailed recommendations on the protection of
combustible material are given in BS. 5440- 1:2000.
NOTE
It is absolutely essential to ensure, in
practice, that products of combustion
discharging from the terminal cannot re-
enter the building or any other adjacent
building through ventilators, windows,
doors, other sources of natural
air infiltration, or forced ventilation/air-
conditioning.
If this could occur the appliance MUST be turned off
(with the owners permission), and labelled as unsafe
until corrective action can be taken.
DANGER!
Only use Buderus flue gas systems. As
other flue gas systems are not tested with
this appliance.
1.7.2 Air supply and flue gas exhaust in a closed
installation
A ventilation cover is integrated into the 600 Series
condensing gas system boilers. This cover houses a
number of components, such as the burner and the heat
exchanger. Since this ventilation cover is part of the air
supply system, it is vital that it is always installed
correctly.
To ensure optimal operation, the 600 Series appliances
must be connected to a Buderus horizontal or vertical
flue terminal. These terminals have been developed
specifically for Buderus condensing gas boilers and
have been comprehensively tested for trouble free
operation when correctly installed.
Standard horizontal flue pack (fig. 11):
– item 1: Flue turret 60/100;
– item 2: Horizontal flue terminal 60/100;
– item 3: Flue finishing kit.
Buderus • http://www.buderus-domestic.co.uk
22 Installation and servicing instructions for wall-mounted condensing gas boiler Buderus 600 - 11R/19R/24R • 02/2006
1
Fig. 11 Standard horizontal flue pack
Fig. 12 Side flue and rear flue installation
Subject to modifications resulting from technical improvements!
2
3
L
415 mm
8 mm