Control Specifications - Sanyo SPW-C483GYH8 Service Manual

1. Outdoor Unit

1-3. Control specifications

MODEL No.
1
Thermostat
Mode setting
Alarm message
Compressor contactor (Mg SW) abnormal
*Cold draft prevention
Defrosting control*
Service function
System control
*: Only for heat pump type.
Outdoor Unit
Cooling
Available
Dry
Setting temp.
Heating
Operation mode
Fan speed
Timer
Auto. flap
Serial communication
Improper address setting & others
Activation of protective device
Thermistor failure
Fault with comp. & its circuit
Timer
Indoor unit coil temp. E2 < 27 °C
Reverse cycle, microprocessor control
Sensor temp. recall function
Past service warnings recall function (Max. 4 alarms)
Multiple remote control
Group control
Automatic restart after power interruption
Test run function (built in 60 min. timer)
ECO MULTI SYSTEM Unit Spesifications
SPW – C483GYH8 / SPW – C483GY8
SPW – C703GYH8 / SPW – C703GY8
SPW – C903GYH8 / SPW – C903GY8
18 – 30 °C
18 – 30 °C
16 – 26 °C
HEAT* • DRY • COOL • FAN
Auto • Hi • Med • Lo
ON • OFF • (Max. 72 hour)
Fan Aim / Sweep
E1 – E 7
E8 – E18
P1 – P17
F1 – F 9
H1 – H12
H9 & H19
Max. 2 controllers (Main : 1, Sub: 1)
Simultaneous operation Max. 8 units
I - 12
–
SM830052