Omron NT31 Setup Manual page 206

System Maintenance
194
Display/set clock data by following the menu operation from the System Menu
shown below.
Ver 3.10
• Pressing Abort causes the NT31/NT31C to return to the date and time display
without executing setting (with the previous settings still effective).
Select Maintenance Mode.
Select Calendar Check.
Press Set.
If you are just checking the display, press
Quit at this point; the NT31/NT31C will return
to the MAINTENANCE MODE MENU
screen.
Set the date.
Each of the digits of the year, month, date,
hour, minute, and second settings, and the
day of the week setting, are touch switches:
press these touch switches to change the cor-
responding settings.
Press Quit.
The clock data is set and the NT31/NT31C re-
turns to the date and time display.
Section 6-11