Clarity WN-5220-S User Manual page 92

Clarity Visual Systems
Color Balance † *
Wht Gry
Red 031 007
Green 031 007
Blue 031 007
Curtain Select
[ ] Curtain On
Lamp Hours: xxxx
System Hours: xxxx
Reset Lamp hours
[ ] Yes [ ] No
Was Lamp Changed?
[ ] Yes [ ] No
ID ‡
Group 0
Unit 2
Misc Control
[ ] Sharpness
[ ] 16M Colors
[ ] Buzzer Enable
[ ] Flip Horz
[ ] Flip Vert
[ ] Auto Lamp On
[ ] Test Patterns
Test Patterns
[ ] Off
[ ] White
[ ] Black
[ ] 50% Gray
[ ] Red
[ ] Green
[ ] Blue
[ ] Geometry
[ ] Gray Scale
Monitor Select ‡
[ ] IR Disabled
June 1999
84
Wht (white) values 000 – 031; Gry (gray) values 000-007
Left-right arrows change Red values of White or Gray Color Balance
Left-right arrows change Green values of White or Gray Color
Balance
Left-right arrows change Blue values of White or Gray Color Balance
Enter turns Curtain on and off. X means Curtain is on and no video
will be displayed.
Shows number of hours lamp was on since last Lamp Hours Reset
Shows number of hours system (Electronics Module) has been used
To reset lamp hours, use left-right arrows to highlight [ ] Yes, then
press Enter. New menu (below) asks for confirmation.
To confirm lamp hours reset, use left-right arrows to highlight
[ ] Yes, then press Enter.
Shows Group ID of this display unit; hexadecimal number
Shows Unit ID number of this display unit. Used for Wall Processor
calculations; hexadecimal number. Unit number times 2 equals lamp
turn-on delay time in seconds.
Turns Sharpness on and off (should be on for PC and MAC)
Turns 16 mullion color mode on and off; off = 256k colors
Turns Buzzer (at each press of a remote control button) on (X) and off
Reverses image left-right
Reverses image up-down
When X is present, lamp tries to turn on after the standby delay has
elapsed.
Opens Test Patterns menu; patterns are internally generated.
No test pattern; external video passes through to screen
Internal White field
Internal Black field
Internal Gray (50% white) pattern
Internal Red field
Internal Green field
Internal Blue field
Internal grid pattern showing edges of LCD image; outside edge is
one pixel of white
Internal pattern ranging from black to white (left to right)
Prevents stray infra-red radiation from disturbing Electronics Module.
Also used to turn off IR reception in some units so remote control
does not change them. When X is present, only ID button on remote
control will affect the unit.