Clarity WN-5220-S User Manual page 52

Clarity Visual Systems
1. Press the remote control MENU
2. Press the Up/Down arrow keys
3. Press ENTER
4. Press the Up/Down arrow keys
5. Press the Left/Right arrow keys
6. Press the Up/Down arrow keys
7. Press the Left/Right arrow keys
8. Press the Up/Down arrow keys
9. Press the Left/Right arrow keys
Shortcut: Unless you have made changes to a source or mode that
you do not want to save, it is easiest and safest to Save All sources,
All modes.
June 1999
44
button
to highlight the upper pair of
arrows
# # # # $ $ $ $
to highlight the lower pair of
arrows
# $ # $
# # $ $
to highlight Save (or Recall or
Reset)
to highlight Yes
The Main menu is displayed.
Move the cursor to the Save Config (or Recall Config
or Reset Config) selection.
The Save Config (or Recall Config or Reset Config)
menu is displayed.
This is the Source selection area. The list of sources
is shown in the right column, with the current
selection preceded by a bullet
the arrow symbols.
Use the left/right buttons to choose the Source you
want to Save/Recall/Reset.
This is the Mode selection area, where you will
choose the modes that will be Saved/Recalled/Reset
for the previously selected Source. There is a
separate memory for each source in each mode.
Use the left/right buttons to choose the Mode you
want to Save/Recall/Reset. (If the Source is "ALL,"
the only choice for Mode is also "ALL.")
Press ENTER. A new menu appears as shown
below.
Save Configuration
# $ # $
# # $ $
PC
# $ # $
# # $ $
ALL
Save
Are you sure?
Yes No
Press ENTER. The settings will be
saved/recalled/reset for the Sources and Modes you
chose. A brief message appears, replacing Yes No
with Saving Settings, Recall Settings, or Restore
Defaults. Then the highlight goes back to the top.
• • • •
and stated next to
Sure