Table of Contents
Advertisement
Clarity Visual Systems
5.
Align the adapter plates on the
units above the Base Unit,
working upward.
June 1999
18
8
6
2
B.
The diagram above shows the order in which you
should align the displays in a typical video wall.
(Note: This is not the same as the Unit ID
address of the display units.)
C. The Alignment Tool fits over the seam of two
adjacent adapter plates. The Tool has six guide
pins, three on each side, and four spring-loaded
screws, two on each side. (Only two of the spring-
loaded screws, one on each side, will be used at
a time.)
D. Position the Alignment Tool between the two
displays. One of these (#1) is already square and
the other (#2) is about to be aligned. Fit the tool
into display #1 first and attach it with the lower
spring-loaded screw. The guide pins should go
into the Alignment Holes in display #1.
E.
Loosen the two Locking Screws in #2 on its right
side under the Alignment Tool and move the
adapter plate of display #2 until the guide pins go
in the Alignment Holes. Secure the Alignment
Tool to #2 with the spring-loaded screw. Tighten
the two Locking Screws on #2 under the
Alignment Tool. (Do not be concerned about the
units in the row above at this time.)
F.
With the Alignment Tool still in place, check
display #2 for squareness by measuring the
diagonals. Loosen the Locking Screws on #2 that
are on the other side from the Alignment Tool,
and adjust adapter plate #2 until it is square-
cornered rectangle.
G. When you are satisfied that display #2 is aligned
to display #1 and it has perfectly square corners,
remove the Alignment Tool. (If you have two
Alignment Tools, leave this first one in place, and
put the second on the other side.)
H. Go to the display on the other side of the center
display (#3) and align it to the center display,
following the steps 4.C through 4.G.
A.
Start with the display above the Base Unit. Align
display #4 to display #1. Put the Alignment Tools
on either side of the Base Unit, #1. The upper
guide pin should now fit the bottom Alignment
5
9
4
7
1
3
Advertisement
Table of Contents
