Table of Contents
Advertisement
Clarity Visual Systems
Function
Auto re-strike Controls
System status request
Enable / Disable Auto re-strike
Test Signal Controls
Test Signal Disable (Pass Video)
Test Signal - White Field
Test Signal - Black Field
Test Signal - 50% Gray Field
Test Signal - Red Field
Test Signal - Green Field
Test Signal - Blue Field
Test Signal - Geometry
Test Signal - Gray Ramp
Test Signal -
Test Signal - Data Red
Test Signal - Data Green
Test Signal - Data Blue
System Monitor
Ping
Product ID
Version ID
Big Picture Controls
Wall Horizontal Size
Wall Vertical Size
Wall Mode Calculate
Wall Mode On/Off
June 1999
94
RS-232 COMMANDS
Inc
Dec
LF1
LF0
TSD
WHT
BLK
GRY
RED
GRN
BLU
GE1
GE2
WMC
WM1
WM0
RS-232
DATA
Get
Set
S0$
Bit 7:
Bit 6:
Bit 5:
Bit 4:
Bit 3:
Bit 2:
Bit 1:
Bit 0:
The system state can have the
following values
0000 – Lockout state
0001 – Standby state
0010 – Run state
0011 – Force on ignition state
0100 – Manual ignition state
0101 – Ignition state
0110 – Re-strike state
All others are not used.
LF*
LF1 – auto re-strike active
LF0 – auto re-strike inactive
TS*
TSD removes test signal and allows
video to show. 0 = off,
1 = White, 2 = Black, 3 = Gray,
4 = Red, 5 = Green, 6 = Blue,
7 = Geometry, 8 = Gray Ramp
TS*
0 = off, 1 = on
TR#
Set test signal red level 0-255
TG#
Set test signal green level 0-255
TB#
Set test signal blue level 0-255
PNG
Verifies that a cube is at an address
P00
Gets the product ID (hex)
0x01 – WN-5220-V; VN-4020-V
0x02 – WN-5220-S
0x03 – WN-5240-S
0x04– SN-4210-P
0x42 – WN-5220-S with VIP-300 &
Big Picture
0x43 – WN-5240-S with VIP-300 &
Big Picture
VER
Get software version ID
0x01 – Rev A
0x02 – Rev B
0x03 – Rev C
etc.
WXn
WX$
n=1..4
Wyn
WY$
n=1..4
WM*
WM* returns WM1 or WM0
Comments
Lamp status (1=on; 0=off)
Lamp failure (1=fail; 0=OK)
Not used
Not used
System state: bit 3
System state: bit 2
System state: bit 1
System state: bit 0
Advertisement
Table of Contents
