Clarity WN-5220-S User Manual page 32

Clarity Visual Systems
2. Press the remote
control ON button to
power up each Display
3. Check for normal
operation
June 1999
24
You will hear a 'beep," and the sound of the internal fans.
The lamp will come on, but will require approximately 5
minutes to fully warm up. There is a built-in delay from
when you press the remote's ON button to when the lamp
lights. The extent of the delay depends on the Monitor ID
Unit setting. The two switches have a total number of 256
individual Monitor ID settings.
GROUP ID numbers are 0-9 and A-F for a total of 16
different settings. Each number is equal to that
number times 16. A setting of 3 is equal to 48.
UNIT ID numbers are 0-9 and A-F for a total of 16
different settings. Each number is equal to that
number times one. A setting of C equals 12.
The Monitor ID number is the combination of the Group ID
plus the Unit ID. A Group ID number of 2 and a Unit ID
number of 5 equals a Monitor ID of 37.
The delay the time between an "on" command to the
display and the ignition of the lamp is approximately 2
seconds times the Monitor Unit ID number.
Observe the LED on the rear of each unit. When proper
power is on, the STBY LED is off, and the fan and lamp
LEDs are on. A faint glow from the lamp exhaust vent in
the rear of the unit indicates the lamp is on.