Accessing Sat From A Cli; Physical Connections To Media Gateways - Avaya S8300 User Manual

Accessing SAT from a CLI

The System Access Terminal (SAT) program can be accessed from a command line interface as follows:
1 . Make sure you have a valid Ethernet or serial connection from your computer to the S8300
Media Server, or another media server (such as the S8700) that is running MultiVantage software.
2 . If you already have a valid CLI connection in progress, access the SAT program by typing sat
or dsat. Go to step 4.
3 . If you are not yet logged in, open a telnet program on your computer. For example:
- On a Windows system, go to the Start menu and select Run.
- To log in directly to the SAT program, type telnet <IP address> 5023
4 . Log in to the MultiVantage software. At the Login prompt, type the appropriate user name (such
as cust or craft).
5 . Enter your login confirmation information as prompted:
- Password prompt. Type your password in the Password field, and click Login or press Enter
again.
- ASG challenge. If your login is Access Security Gateway (ASG) protected, you will see a
challenge screen. Enter the correct response and click Login or press Enter.
6 . Enter your terminal type. Accept the default value, or enter the appropriate type for your
computer. For example, use type ntt.
7 . The SAT interface appears. Enter SAT commands as appropriate.

Physical Connections to Media Gateways

This section describes how to physically connect a computer to the S8300 Media Server or G700 Media
Gateway. See Figure 1 for an illustration of these physical connections. Setups covered include:
• Connecting directly to the G700 serial port
• Connecting a modem to a USB port
• Connecting to an Ethernet interface
• Setting up a laptop for an S8300 Media Server direct Ethernet connection
Welcome to S8300 and G700
555-234-200 — Issue 1 — May 2002
Access Procedures: Physical Connections to Media Gateways
27