Sony BVP-900 Series Product Information Manual page 69

and on the CCU and MSU are illuminated.
17) POWER switch
Selects the power source.
CCU: Power is supplied from the CCU.
(Standby): Standby mode.
EXT: Power is supplied from the VTR or via the EXT DC IN
connector (see 9)).
18) DC OUT (direct current output) connector (4-pin)
Outputs 10.5 V to 17 V DC up to a maximum of 500 mA. Connecting
equipment with a power consumption greater than this maximum
rating will activate the protection circuit, cutting off the current.
19) PROD/ENG (producer/engineer) intercom level controls,
PROD/ENG (producer/engineer) switches, and LEVEL/MIC
(intercom level/microphone) switch (CA-570P only. See 4) for
CA-570)
PGM (program) level control
Adjusts the audio volume of the program line.
ENG (engineer) level control
Adjusts the audio volume of the engineer's line.
MIC LINE switch
Selects the line to which the headset microphone is connected.
ENG: connected to the engineer's line.
OFF: microphone switched off.
PROD: connected to the producer's line.
PROD (producer) level control
Adjusts the audio volume of the producer line.
TRACKER level control
Adjust the audio volume of the tracker line.
LEVEL/MIC (intercom level/microphone) switch
The LEVEL and MIC switch settings control the following
functions:
REAR/ON: Turns on the intercom microphone. Adjust the
intercom reception level with the PGM, ENG, PROD
and TRACKER level controls.
REAR/OFF: Turns off the intercom microphone. Turn the
intercom microphone on and off using the control
on the external equipment connected to the RET
CONT connector. Adjust the intercom reception
level with the PGM, ENG, PROD and TRACKER
level controls.
FRONT/OFF: Turns off the intercom microphone. Turn the
intercom microphone on and off using the control
on external equipment (such as a pan bar box)
connected to the RET CONT connector. Use the
control on the camera to adjust the intercom
reception level.
Location and Function of Parts and Controls
10
68