Sony BVP-900 Series Product Information Manual page 121

1) Tilt knob
Adjust for the desired tilt friction.
2) PEAKING control
Enhances the edge sharpness of the displayed image when the
PEAKING switch 3) is set to ON. The adjustable range is from 0 dB
to more than 15 dB. This control has no effect on the video output
signal from the camera.
3) PEAKING switch
ON: The PEAKING control 2) is activated and the edge
sharpness of the picture can be enhanced.
OFF: The PEAKING control is deactivated. The peaking control
can be turned off with a control signal sent from the
camera even if the PEAKING switch is set to ON.
4) Red tally lamps
Illuminate when the camera accepts a red tally signal. The brightness
of these lamps is adjustable with an internal control.
5) BRIGHT control
Adjusts the picture brightness. This control has no effect on the
video output signal from the camera.
6) Tilt lock lever
Pushing the lever forward toward the lens locks the viewfinder.
Moving it back toward the camera operator allows the tilt friction to
be adjusted with the tilt knob 1).
7) Lift-lock release knob
Releases the lock on the viewfinder position. Pull the knob and the
lock is released so that the viewfinder position can be raised to the
middle or top position from the factory-set standard position.
8) POWER/DEGAUSS switch
OFF (lower): The power supply to the viewfinder is turned off.
ON (center): The power supply to the viewfinder is turned on.
Adjusting the Angle of the Viewfinder
Lift-lock release knob
Middle position
You can adjust the angle of the viewfinder so that you can see the
screen comfortably.
Location and Function of Parts and Controls
DEGAUSS (upper): When an external magnetic field affects
9) Green tally lamps
Illuminate when the camera accepts a green tally signal. The
brightness of these lamps is adjustable with an internal control.
10) SCAN SIZE switch
NORMAL: The screen size is normal. Generally use this
position.
NARROW: The screen size is reduced by 80 % of the normal
size. Use this position when monitoring a picture at a
distance from the viewfinder when the optional
outdoor hood is attached.
The function of this switch is changed by a control signal from the
camera or by setting the internal switch appropriately. The aspect
ratio can be changed to 4:3 or 16:9 with this switch.
11) CONTRAST control
Adjusts the picture contrast. This control has no effect on the video
output signal from the camera.
12) Up-tally lamp
Functions the same as the red tally lamps 4). To deactivate this lamp,
set the UP TALLY switch on the camera to OFF.
* To adjust the brightness of the up-tally lamp, refer to the
operation manual provided with the camera.
* To display the camera number, attach one of the supplied plates,
numbered from 0 through 9.
13) Camera connector (D-sub 25-pin)
Connects to the viewfinder connector on the camera.
30°
30°
Upper position
Tilting the viewfinder
The range of adjustment can be changed by altering the position
of the lift-lock release knob.
color reproduction, keep the switch at this
position until the correct color is obtained.
This takes about one second.
60°
40°
10
120