Print A Test Page; Print Settings - Brother HL-5130 Service Manual

CHAPTER 2 INSTALLATION AND BASIC OPERATION
5.5.2

Print a test page

You can use the Go button or the printer driver to print a test page.
<Using control panel button>
(1) Turn off the printer.
(2) Make sure that the front cover is closed and the power cord is plugged in.
(3) Hold down the Go button as you turn on the power switch. All the LEDs light up. Keep the
Go button pressed down until all the LEDs except for Toner LED go off. When the Drum,
Paper and Status LEDs go off, release the Go button.
(4) Press the Go button again. The printer will print a test page.
<Using the printer driver>
If you are using Brother's Windows PCL printer driver, open the printer folder, then choose and
right click the Brother's Windows PCL printer driver. The Print Test Page button is in the
General Tab of the "Property".
5.5.3 Printer Settings
You can print the current settings using the control panel button or printer driver.
<Using control panel button>
(1) Make sure that the front cover is closed and the power cord is plugged in.
(2) Turn on the printer and wait until the printer is in Ready state.
(3) Press the Go button three times. The printer will print the current printer settings.
<Using the printer driver>
If you are using Brother's Windows PCL printer driver, you can print the current printer
settings by clicking the Print Settings button in the Support tab.
Fig.2-45
Fig.2-46
2-34