Brother HL-5130 Service Manual page 141

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
NOTE:
When re-assembling the paper eject actuator and the eject actuator spring to the FU frame
lower, ensure the paper eject actuator is seated correctly in the locating channel referring to
the figure below;
(28) Disconnect the heater harness.
(29) Remove the four cup B M3x6 Taptite screws.
(30) Remove the four claw holder plate.
(31) Remove the four separate claw ASSY.
Separate claw ASSY
Heater harness
Paper eject actuator
Claw holder plate
FU frame lower
Eject actuator spring
Fig. 4-70
Taptite, cup B M3x6
Tweezers
Fig. 4-71
4-40
Separate claw ASSY