Print A Test Page - Brother HL-2030 Service Manual

CHAPTER 2 INSTALLATION AND BASIC OPERATION
(3) Fan the stack of paper well to avoid paper jams and misfeeds.
(4) Put paper in the paper tray. Check that the paper is flat in the tray and below the
maximum paper mark.
NOTE:
• Paper jams may occur if you put more than 250 sheets (80g/m² or 21 lb) of plain paper in
the paper tray at one time.
• Paper jams may occur if you put more than 10 transparency in the paper tray at one time.
• When you use pre-printed paper, put the side that is going to be printed on (blank side) face
down, with the top of the paper at the front of the tray.
(5) Put the paper tray firmly back in the printer. Check that it is completely in the printer.
3.1.3

Print a test page

(1) Turn off the printer.
(2) Make sure that the front cover is closed and the AC power cord is plugged in.
(3) All LEDs light up, and keep the Go button pressed down until the Ready LED goes off.
Release the Go button. Make sure that the Toner, Drum and Paper LEDs are off.
(4) Press the Go button again. The printer will print a test page.
Fig. 2-4
Fig. 2-5
2-6 Confidential