Brother HL-5130 Service Manual page 261

3. Set the serial number
<PIT3>
1) Follow the same step as procedure 2) and 3) above.
2) Move the folder to "PIT3" in DOS window and type "PIT3", then press ENTER key. PIT3
(software tool) will start.
3) Input model code in PIT3 control window, then press ENTER. "CSXXXX (SCRPTY.YY)"
message appears in the model section of PIT3 control window. *3
4) Input ".VVVVV", then press ENTER.(.VVVVV expresses a country code. See the detail
below.) *4
ex. If you Input ".00101 (USA version) , "00101 (USA / USA)" message appears in the
specification section of PIT3 control window, and "READY" message appears in the PIT3
status window.
5) Input 9 digit serial number in the PIT3 control window, then press ENTER. PIT3 will be
started, "RUNNING" message appears in the PIT3 status window accordingly.
6) "SER:VVVVVVVVVVVVVVVVVV" message appears in the PIT3 control window, and
"PASS" message appears in ERR CODE section. "READY" message appears in the PIT3
status window. (READY is displayed in about 3 seconds.)
<When the error occurs>
The error generated step appears in the PIT3 control window, error code appears in ERR
CODE section, "ERROR" message appears in the PIT3 status window. To release the
error, Input "check", then press ENTER.
Please carry out (9) again at the time of error generating. If the error message still
appears, please judge that there is something wrong with PCB.
7) Turn the printer power switch OFF, then disconnect the USB cable.
8) In case of performing the rewriting work to other printers, repeat from the step 2. To finish
working, Input "quit" in the PIT3 control window, then press ENTER key.
9) Turn off the printer. Serial number and the other settings will be effective when the printer
is turned on.
HL-5130/5140/5150D/5170DN SERVICE MANUAL
7-19