Brother HL-5130 Service Manual page 113

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
NOTE:
• When re-assembling the side guide racks, they should both be aligned so that the wide
end of the racks are in line with the inside edge of the paper guide release slots in the tray
before refitting the spring and gear.
• When replacing/re-assembling the paper tray, remove the old grease and apply a suitable
amount of grease onto both sides of the paper tray referring to the figure below;
Grease: Molykote PG-662
(2 mm dia. ball)
(22) Remove the pan B M3x8 Taptite screw, and then remove the tray lock lever.
(23) Unhook the four hooks to remove the paper tray rear from the paper tray.
Fig. 4-18
Taptite, pan B M3x8
Tray lock lever
Hook
Paper tray
Fig. 4-19
4-12
Paper tray
Paper tray rear
Hook
Hooks
Grease: Molykote PG-662
(2 mm dia. ball)