Brother HL-5130 Service Manual page 136

(10) Remove the two pan (washer) M26x8 Taptite screws.
(11) Remove the heat roller 25.
(12) Remove the halogen lamp.
Screw, pan (S/P washer)
M26x8
Washer, Plain 26
FU frame upper
NOTE:
When re-assembling the halogen heater lamp, ensure that the direction of the halogen heater
lamp is correct referring to the figure above.
!
CAUTION:
• Never touch the surface of the halogen heater lamp.
• When securing the screw to assemble the halogen lamp connector plate, ensure you use
the plastic jig as shown in the figure below to avoid damaging the edge of the halogen
heater lamp.
Halogen heater lamp
Heat roller 25
Heat roller 25
Halogen lamp
Halogen lamp connector plate
Fig. 4-60
Screw, pan (S/P washer) M26x8
Washer, Plain 26
Fig. 4-61
4-35
HL-5130/5140/5150D/5150DN Service Manual
Halogen lamp
Screw, pan (S/P
washer) M26x8
Washer, Plain 26
Colored side
115V:Orange
230V:Black
Halogen lamp
connector plate
Plastic jig