JRC JMA-9832-SA Instruction Manual page 138

Exit 1 Press
The TEST Menu will be closed.
Note: When performing a LAMP test, the operation cannot be checked if the brilliance
level of the key backlight is at maximum.
3 ARPA TEST
3-1 SIMULATOR
Refer to (3) Checking ARPA in Section 8.1.1 Function Check on Test Menu.
Procedures 1 Press
2 Press
The TEST Menu will appear.
3 Press
The ARPA TEST Menu will appear.
4 Press
1.SIMULATOR
will appear.
5 Select any setting item of ARPA Simulator in the pull-down menu and press any
1
of
6 Press
Exit 1 Press
The TEST Menu will be closed.
TEST
.
TX
STBY
to set the standby mode.
TEST
.
3
.
1
.
will be selected and the pull-down menu
3
to .
TX
STBY
to set the transmission mode.
TEST
.
3 – 67
T E S T M E N U
ARPA TEST
1.SIMULATOR
1. OFF
1. OFF
2.TEST VIDEO
2. SCENARIO1
3. SCENARIO2
3.
STATUS
0. E X I T