Reset Alarm Buzzer - JRC JMA-9832-SA Instruction Manual

[3 3 ] Guard Zones ON/OFF Allotment to the ACQ AUTO Switch
A guard zone is set so that the display is turned ON or OFF when the [ACQ AUTO] switch is pressed.
1 After end of the Procedures for [1 1 ] Creation of Fan-
Procedures
shaped Guard Zone, press
5.SET ACQ AUTO KEY
menu will appear.
2 Press
1. GZ1
allotted to the [ACQ AUTO] switch.
3 Press
2. GZ2
allotted to the [ACQ AUTO] switch.
4 Press
3. GZ1&GZ2
[ACQ AUTO] switch.
1 Execute the Exit step in the same Procedures for [1 1 ] Creation of Fan-shaped Guard
Exit
Zone.

......Reset Alarm Buzzer

ALARM ACK is the function of acknowledging the alarm item when an alarm sounds, and
stopping an alarm sound as well as cancelling the selected of alarm indication. (If there are
two or more alarms, it is necessary to operate the switch for each alarm indication.) The alarm
sound can be stopped, but the alarm indication is not cancelled.
Stopping Alarm Sound
Procedures 1 Press
The alarm sound will be stopped.
will be selected and the pull-down
1
to allot an area to Guard Zone 1.
will be set and the area for Guard Zone 1 will be
2
to allot an area to Guard Zone 2.
will be set and the area for Guard Zone 2 will be
3
to allot the areas for both Guard Zones 1 and 2.
will be set and the areas for both Guard Zones 1 and 2 will be allotted to the
ALARM ACK
ALARM
.
ACK
5
.
.................................
3 – 61
G U A R D Z O N E
1.GUARD ZONE1 (GZ1)
OFF ON
2.GUARD ZONE2 (GZ2)
OFF ON
3. MAKE GZ1
(0.5NM-32NM)
4. MAKE GZ2
(0.5NM-32NM)
5.SET ACQ AUTO KEY
1. GZ1
1. GZ1
2. GZ2
3. GZ1&GZ2
0.
E X I T