Correcting Uneven Print Quality - Intermec EasyCoder 3240 Getting Started Manual

Correcting Uneven Print Quality

You may experience problems in print quality (ribbon wrinkling or light print
on one side of your label) if the printhead is not making even contact with the
label stock. This condition can happen with any size label stock, but it is most
common when using narrow label stock (1.0 inch or less). You need a straight-
slot screwdriver to turn the bias adjust screw.
Note: To achieve the best print quality, adjust the bias adjust screw each time you use
media of a different width.
To adjust the bias adjust screw
1. Remove the media cover and locate the bias adjust screw.
P o
w e
r
A le
rt
E m
p ty
/P
a u
s e
F e
e d
/P
a u
s e
Co de 39 Co de 39
Optimizing Print Quality
3
Bias adjust
screw
3240G.013
3-11