Intermec EasyCoder 3240 Getting Started Manual page 20

NugFont
HelvC Courier
Loading Media for Self-Strip Printing
Media
liner
Media
access door
11. Pull out 10 to 12 inches of media and remove the exposed labels from the
12. Open the media access door and thread the media liner under the self-strip
13. Remove the rewinder clasp from the rewinder hub and wind approximately
14. Secure the media by snapping the rewinder clasp onto the rewinder hub.
15. Close the media access door.
16. Use PrintSet, your third-party software or the printer command set to
17. Rotate the head lift lever counterclockwise until it locks.
18. Press Feed/Pause to advance approximately 6 inches of media through the
C o d e 39
Lateral
printhead
knob
Head lift
lever
P o
w e
r
A le
r t
E m
p ty
/P
a u
s e
F e
e d
/P
a u
s e
Tear
Self-strip
bar
assist roller
Printhead
media liner.
assist roller and over the rewinder hub in a clockwise direction.
2 inches of media liner over the rewinder hub.
Turn the rewinder hub clockwise to remove all slack from the media liner
between the tear bar and the rewinder hub.
enable self-strip printing and the label taken sensor.
Note: See "Adjusting the Printer for Self-Strip Printing" in Chapter 3 for
information on how to position the label taken sensor.
printer. Remove the stripped labels from the front of the printer.
Preparing the Printer for Connection
Media
brake
Upper media
guide
Lower media
guide
Rewinder
hub
Rewinder
clasp
1
Media
support
Supply roll
retainer
Media roll
Supply roll
post
3240G.020
1-11