Optimizing And Maintaining Print Quality; Correcting Uneven Print Quality - Intermec EasyCoder 3400e User Manual

Chapter 5 — Optimizing Printer Performance

Optimizing and Maintaining Print Quality

Correcting Uneven Print Quality

48
C d
Intermec designed and configured your printer to provide the best possible
print quality for both direct thermal and thermal transfer media. However,
there are many factors that you need to take into account before you can
achieve maximum print quality.
You may experience problems in print quality (ribbon wrinkling or light
print on one side of your label) if the printhead is not making even contact
with the label stock. This condition can happen with any size label stock,
but is most common when using narrow label stock. You need a straight-
slot screwdriver to turn the bias adjust screw.
To achieve the best print quality, adjust the bias adjust screw each time
you use media of a different width.
Note: You must properly adjust the bias adjust screw to prevent premature
printhead failure and excessive platen wear.
To adjust the bias adjust screw
1 Remove the media cover and locate the bias adjust screw.
P o
w e
r
A le
rt
E m
p ty
/P
a u
s e
F e
e d
/P
a u
s e
In t e In t e
r m e r m e
c c
3 4
0 0
2 To compensate for uneven print quality, turn the bias adjust screw as
shown. Adjusting the bias adjust screw causes the printhead to rest
evenly on the drive roller and results in even print quality.
39
Helvetica Condensed Helvetica
EasyCoder 3400e Bar Code Label Printer User's Manual
Bias adjust
screw
3XXXU.038