Intermec EasyCoder 3240 Getting Started Manual page 18

NugFont
HelvC Courier
Loading Media
Media
Media
backing
13. Press the Feed/Pause button until the printer feeds out approximately 6
14. Unscrew the edge guide and slide it inward until it just touches the edge of
15. If you are loading continuous media or mark label stock, use PrintSet™,
16. Replace the media cover. Your printer is now ready to print labels.
Note: If you are using narrow media (1 inch or less), it is important that you adjust
the bias adjust screw to achieve the highest print quality possible. For help, see
"Correcting Uneven Print Quality" in Chapter 3.
C o d e 39
Head lift
lever
Printhead
TOF
Tear
Label
bar Edge
gap guide
sensor
inches of media.
the media. Screw it in place.
Note: Adjust the label gap sensor if you are using narrow media (less than
1 inch wide). For help, see "Accurately Detecting the Start of a Label" in
Chapter 3.
your third-party software or the printer command set to tell the printer
what kind of media you are using.
Preparing the Printer for Connection
Lateral
Upper
printhead
media guide
adjust
Lower
media guide
1
Media
brake Media
support
Media roll
Supply roll
post
Supply roll
retainer
3240G.005
1-9