Display Indications - Yaesu FT dx 1200 Operating Manual

D i
isplaY nDications
Configuration Indicator
TUNER
This indicator appears when the internal Automatic
Antenna Tuner is activated.
VOX
This indicator appears when the automatic voice-
actuated transmitter switches in the SSB, AM, and
FM modes.
PROC
This indicator appears whenever the DSP Speech
Processor is activated.
MIC EQ
This indicator appears whenever the Three-Band
Parametric Microphone Equalizer is activated via
the Menu.
NAR
This indicator appears whenever the receiver's
narrow IF DSP filter is engaged.
REC
This indicator appears while the optional Voice
Memory Unit is recording your voice message, or
the Contest Keyer is recording your CW keying.
PLAY
This indicator appears while the optional Voice
Memory Unit is playing back the recorded voice
message, or the recorded Contest CW keying.
[+]/[-]
During FM repeater operation, a negative frequen-
cy shift will be indicated by "[-]" while a positive
frequency shift will be indicated by "[+]".
DNR
This indicator appears whenever the Digital Noise
Reduction feature is activated.
DNF
This indicator appears whenever the Digital Notch
Filter is activated.
VFO-B Frequency Display
Shows the sub band (VFO-B) frequency during Split
operation.
A :
dvice
 When turning the [ CLAR ] , [ MIC/SPEED ] ,
[ PROC/CAR ] , [ NOTCH ] , [ CONT/APF ] ,
[ SHIFT ] , or [ WIDTH ] knob, each frequency or
value will appear in this area for 3 seconds.
Page 26
Tuning Offset Indicator
This indicates the relative offset of the CW-TUNE,
μ-TUNE, Clarifier, etc.
S/PO Meter
On reception, this indicates the received signal
strength from S-0 to S-9+60dB.
On transmission, this indicates the RF Power Output,
from 0 to 150 Watts.
A :
dvice
The S/PO meter types can be changed to

ANALOG or BAR type via the menu item "012
METER TYPE SELECT".
The S/PO meters can be set to the Peak-hold

function (BAR type only) via the menu item "013
BAR MTR PEAK HOLD".
DSP Display
This indicator is used for viewing the status of the
DSP (CONTOUR, NOTCH, WIDTH and SHIFT).
Key Function Display
ANT ( 1, 2 ) :
Indicates which antenna is selected by the front
panel [ ANT ] button.
IPO ( AMP1, AMP2, IPO ) :
Indicates which front end RF amplifier is selected
by the front panel [ IPO ] button.
ATT ( OFF, –6 dB, –12 dB, –18 dB ) :
Indicates the attenuation level, selected by the
front panel [ ATT ] button.
R.FLT ( 3 kHz, 6 kHz, 15 kHz ) :
Indicates the receiver IF Roofing Filter that is se-
lected by the front panel [ R.FLT ] button.
NB ( OFF, ON, ON [ NBW ]) :
Indicates the receiver's "short-duration" Noise
Blanker setting, which is selected by the front
panel [ NB ] button.
AGC ( SLOW, FAST, MID ) :
Indicates the AGC decay time setting, which is se-
lected by the front panel [ AGC ] switch.
F T 12 00 O
DX
M
peraTing anual