t
ransmitter
S
For split TX/RX operation in "casual" pile-ups, where the split is less than 10 kHz, the TX Clarifier (Offset Tuning) fea-
ture may be utilized.
1. Press the [ TX CLAR ] button. The "TX" icon will
appear in the TFT display.
q
p
:
uick
oint
The Clarifier is frequently used for receiver offset
tuning. However, for DX pile-ups where the DX
station is using a split of less than 10 kHz, the TX
Clarifier function is usually the quickest way to set
the transmitter to the desired offset frequency.
2. Rotate the [ VFO-B/CLAR ] knob to set the desired
transmitter offset. A maximum split of ±9.999 kHz
may be set.
3. To exit from TX Clarifier operation, press the [ TX
CLAR ] button once more. The "TX" icon will disap-
pear from the display.
A
:
dvice
When listening to a "pile-up" calling a DX station,
in order to find the station currently being worked,
you may press the [ RX CLAR ] button. Then, use
the [ VFO-B/CLAR ] knob to zero in on the station
calling the DX (use the SPOT function on CW for
precise alignment of your frequency). You may then
press the [ RX CLAR ] button again to cancel the RX
Clarifier, and return to reception on the DX station's
frequency.
Just as with receiver Clarifier operation, the amount
of offset from the original VFO frequency will ap-
pear in the display.
As with receiver Clarifier operation, when you turn
the TX Clarifier off, the last-used offset is remem-
bered, and will be available if you turn the TX Clari-
fier back on. To clear the Clarifier offset, press the
[ CLEAR ] button.
q
p
:
uick
oint
A visual depiction of the relative offset of the Clarifier may be displayed, using the Tuning Offset Indicator.
1. Press the [ MENU ] button to engage the Menu
mode.
2. Rotate the [ VFO-B/CLAR ] knob (or press the
/ button) to select Menu item "011 BAR
DISPLAY SELECT".
3. Press the [SELECT] button, then rotate the
[ VFO-B/CLAR ] knob (or press the / button)
to select "CLAR" from the available choices; the
factory default is "CW TUNE".
4. Press the [ SELECT ] button, then press the
[ MENU ] button to save the new setting and exit
to normal operation.
FT
1200 O
DX
peraTing
c
o
u
plit
perAtion
Clarifier Offset Indicator
M
anual
onvenience
tx c
Sing the
lAriFier
When attempting to work a DX station on CW in a split
frequency pile-up, remember that a large number of
other stations may also be using Yaesu transceivers with
capability similar to that of your FT
side of the pile-up, everyone calling precisely on the
same CW frequency will sound like a single tone! So
you may have more success if you use the RX Clarifier
to find a hole in the pile-up, instead of trying to zero-
beat the last station worked by the DX station.
TX Frequency = RX Frequency
f
eatures
[ CLEAR ] Button
[ TX CLAR ] Button
[ RX CLAR ] Button
[ VFO-B/CLAR ] Knob
1200. On the DX
DX
Plus (+) Offset
Minus (-) Offset
Page 75