c
onvenience
When using a YAESU model G-800DXA, G-1000DXA, G-2800DXA Antenna Rotator (not supplied), it is possible to
control it from the front panel of the FT
1. Press and hold in the [ ENT ] button (one of the
[ BAND ] key switches) for one second. The TFT dis-
play will change to the "Rotator Control" configura-
tion.
2. Press either the [ 3.5 ( 2 )] button or the [ 7 ( 3 )] button
to rotate the antenna. Pressing the [ 3.5 ( 2 )] button
will cause rotation to the left (counter-clockwise) by
two degree steps, while pressing the [ 7 ( 3 )] button
will cause rotation to the right (clockwise) by two
degree steps.
3. Press the [ 14 ( 5 )] button or the [ 18 ( 6 )] button to con-
trol the speed of rotation. Pressing the [ 14 ( 5 )] button
will cause slower rotation, while pressing the [ 18 ( 6 )]
button will speed up rotation. Usually, you will be
using the "100%" speed setting.
When you are through exercising rotator control, press
the [ ENT ] button momentarily.
i
MportAnt
Set the starting point to match your rotator
control indicator needle via the Menu item
"014 ROTATOR START UP". The default set-
ting is zero (north). If your controller starting
point is south, the Menu item "014 ROTA-
TOR START UP" must be set to "180". If not
set properly the FT
show the correct direction.
When the rotator control indicator needle
does not indicate the precise antenna direc-
tion, calibrate the indicator needle precisely
to the antenna direction via the Menu item
"015 ROTATOR OFFSET ADJ".
Remove the rubber cap first,
and then connect the plug.
Page 42
f
eatures
r
c
otAtor
ontrol
1200.
DX
n
ote
1200 display will not
DX
F
unctionS
Counter-clockwise Rotation
Clockwise Rotation
Speed Down
Speed (0 % -100 %)
"Overlap" Indicator
FT
1200 O
DX
[ 3.5 ( 2 )] , [ 7 ( 3 )] Button
[ 14 ( 5 )] , [ 18 ( 6 )] Button
[ ENT ] Button
Speed Up
Direction (0° - 360°)
M
peraTing
anual