Yaesu FT dx 1200 Operating Manual page 24

f p
ront anel
[ SPLIT ] Switch
Press this button to operate split frequency between
VFO-A (used for reception) and VFO-B (used for
transmission). If you press and hold in the [ SPLIT ]
button for one second, the "Quick Split" feature will
be engaged. VFO-B transmit will automatically be
set to a frequency 5 kHz higher than the VFO-A re-
ceive frequency, with the same operating mode. The
transceiver will operate in the Split mode.
[ V/M ] Switch
This button toggles frequency control between VFO-
A and the memory system. In memory mode, "MEM"
(Memory Channel) will be shown in the display to
indicate the current selection. Pressing the [ V/M ]
button displays the original memory frequency, and
the "MEM" will be displayed. Pressing it once more
returns frequency operation to VFO-A, and the icon
will no longer be displayed.
Page 22
c
ontrols
& s
witches
[ M A ] Switch

Pressing this button momentarily, will display the
contents of the currently-selected memory channel
for 10 seconds.
Holding [ M A ] button in for one second copies the

data from the selected memory to VFO-A, and two
beeps sound. Previous data in VFO-A will be over-
written.
[ A M ] Switch

Pressing this button momentarily, displays the con-
tents of the currently-selected memory channel for
10 seconds.
Pressing and holding in this key for one second (until
the double beep) copies the current operating data
into the currently selected memory channel, over-
writing any previous data stored there.
F T 12 00 O
DX
M
peraTing anual