Honeywell Ademco Vista-12D Installation And Setup Manual page 83

Table of Contents

Advertisement

PROMPT
P A R T I T I O N
X
S T A R T
S M T W T F S
0 0 1 0 0 0 0
H H M M A M
W A R N I N G D L Y T I M E
0 0
S T O P
S M T W T F S
0 0 1 0 0 0 0
H H M M A M
R E P E A T O P T I O N
0 - 4
X
VALID ENTRIES
Partition
0 = all partitions
1 = partition 1
2 = partition 2
3 = common partition
[∗] to continue
Start Time
01-12 (00-23)
= hour
00-59 = minute
0 = AM; 1 = PM (if applicable)
Days = place "1" under days
[∗] to continue
Warning Delay Time
01-15 = arm warning delay time
in minutes
[∗] to continue
Stop Time
01-12 (00-23)
= hour
00-59 = minute
0 = AM; 1 = PM (if applicable)
Days = place "1" under days
[∗] to continue
Repeat Option
0 = do not repeat
1 = repeat schedule weekly
2 = repeat schedule biweekly
(every other week)
3 = repeat schedule every third
week
4 = repeat schedule every fourth
week
[∗] to continue
Menu Mode Programming
EXPLANATION
This prompt appears if events "3-8,10" were
selected. Otherwise it is skipped.
Press [*] to continue to the "Start" prompt.
Enter the event's start time and days of the week
to occur.
To select days, position the cursor under the
desired days using the [∗] key to move forward,
then press "1" to select the day(s).
† use 00-23 if 24-hour time is enabled.
This prompt appears if events "4 or 5" were
selected.
Enter the desired amount of time the system
should warn of impending arming. The system
will beep once every 30 seconds to alert users
that arming will soon occur. Otherwise, this
prompt is skipped.
Enter the event's stop time and days of the
week to occur.
To select days, position the cursor under the
desired days using the [∗] key to move forward,
then press "1" to select the day(s).
This entry applies only to the following events:
1 (relay on/off)
2 (user access)
3 (child-not-home report)
† use 00-23 if 24-hour time is enabled.
Enter the desired repeat option for this
schedule.
e.g., To make a schedule that happens everyday
you would select all days with a repeat count of
1. To make a schedule that runs for one week
then stops, select everyday with a repeat count
of 0.
5-27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents