Engine Cooling System - Dinli DMX 450 Owner's Manual

OWNER'S MANUAL
7-6-3. OIL PUMP PRIMING
This priming procedure must be performed whenever the oil hose connection between the oil tank and pump inlet
has been disconnected.
1. Clamp or pinch off the vent line approximately 2" from the oil tank.
2. Run the engine for 5-10 seconds at idle. Stop the engine and remove the vent line clamp.
If the line is bled properly, you should hear a rush of air, indicating that the line is properly primed and ready for
operation. If you do not hear air, the line has not bled, and you'll need to repeat the priming procedure.

7-7. ENGINE COOLING SYSTEM

7-7-1. COOLANT LEVEL
The engine coolant recovery bottle is located on the left side of the vehicle under the front fender. Check the coolant
level in the bottle when the engine is cold, the fluid level in the bottle will vary during operation. Maintain coolant at
the "LEVEL" mark on the bottle when the engine is cold. We recommend a 50/50 mixture of high-quality aluminum
compatible anti-freeze/coolant and distilled water.
WARNING !
POTENTIAL HAZARD
Severe burns
WHAT CAN HAPPEN
Coolant can sprayed out under high pressure if the bottle is opened while the system is hot.
HOW TO AVOID THE HAZARD
Wait for the engine to cool completely before removing the cap.
92