Dinli DMX 450 Owner's Manual page 91

6. Allow the oil to drain completely.
7. Replace the sealing washer and reinstall the plug & torque to 19 Nm.
8. Place shop towels beneath the oil filter.
9. Remove the three cover bolts and remove the cover.
10. Pull out the oil filter.
11. Using a clean dry cloth, clean the filter sealing surfaces.
12. Replace the o-ring in the cover.
13. Lubricate the gasket on the new filter with a film of fresh engine oil.
14. Reinstall the spring and install the new filter.
15. Install the cover and torque the bolts to 8~9 Nm.
16-1. Remove the dipstick and fill the oil tank with 2200cc oil.
16-2. Idle the engine for 1~5 minute, then fill the oil tank with additional 800cc oil.
17. Place the transmission in Neutral and set the parking brake.
18. Prime the oil pump using the procedure on page 92.
Then stop the engine and inspect for leaks.
19. Dispose of the used filter, oil and shop towels properly.
CAUTION
Do not over-tighten the drain plug. You will damage the threads of the filter housing. If the cover leaks,
you may need to replace the cover O-ring or inspect the cover and housing mating surfaces for damage.
91