Procedures For Older Controllers; Programming The Controller Dhcp Server Settings (Prior To Rel 7.0) - Mitel 3300 Technician's Handbook

Procedures for Older Controllers

Programming the Controller DHCP Server Settings (prior
to Rel 7.0)
For additional information on programming DHCP settings for the 3300
ICP, refer to the System Administration Tool Online Help.
To use an external DHCP Server, do not enable the internal DHCP server
and refer to "Configuring External DHCP Settings for E2T" on page 283 for
instructions.
Tip: You may need to change the IP address of your PC to match your
customer's network.
1. On the Maintenance PC, access the System Administration Tool (see
"Log into the Programming Tools" on page 71).
2. In the All forms (alphabetical) list, click DHCP Subnet form, enter
3. In the DHCP Static IP form, enter a static IP address for the E2T using
the information on page 276 (skip this step for the MX and 100-user
controllers). Assign IP addresses to specific devices by using the MAC
address of the device. Assign a static IP Address to any IP Console in
a cluster.
4. In the DHCP IP Address Range form, program the scope using the
information on page 277. See "Reserved IP Addresses" on page 271.
5. In the DHCP Options form, program the options listed in Table 51 on
page 277 for the scope you just programmed. Always create the
following options:
- 3 Router, IP address
- 66 TFTP Server, IP address format
- 67 Boot file, string value (always /sysro/E2T8260)
- 128 TFTP, IP address format (typically the controller)
- 129 RTC, IP address format (typically the controller)
- 130 MITEL IP PHONE, string value
In a single DHCP configuration, create the following options:
- 132 VLAN ID (optional)
Older Hardware and Software
395