Change Number Of Ip User Licenses; Cluster Or Dimension Changes - Mitel 3300 Technician's Handbook

Change Number of IP User Licenses

If you need to decrease or increase the number of IP User Licenses during
the software installation, perform the following steps to avoid losing all data
at reboot.
Table 10: Changing the Number of IP User Licenses
If you are increasing or decreasing the
number of IPUser Licenses
AND the Maximum Configurable IP Users
and Devices parameter is NOT modified
AND the Maximum Configurable IP Users
and Devices parameter IS modified
Note: The Maximum Configurable IP Users and Devices parameter is only
modified when you are increasing the number of IP User Licenses over 700.

Cluster or Dimension Changes

There are install/upgrade requirements to consider when dealing with
Maximum Elements per Cluster changes or Dimension Selection changes.
Tip: Print a record of the Flex Dimension in case you have to re-program
the Flex Dimension.
Table 11: Maximum Elements Change or Flexed Dimension
Elements / Dimensions
From
Prior to Rel 6.0 Release 6.0
with Flexed with Flexed
Dimensions Dimensions
Selection
MCD Software
Installer
To
Install only. Do not
perform a data
restore with the
Software Installer.
See "Upgrade to Rel
6.0 or later with
Flexed Dimensions"
on page 110.
Software Installation
You MUST do the following:
- save the change
- perform DBMS Save command
- save the change
- perform DBMS Save command
- perform a backup and restore
Notes
After the install is complete,
flex the dimensions, reboot,
and restore using current
dimension selections.
Page 1 of 2
103