X-Axis Procedures - Ioline FlexJet Service Manual

89
Chapter 4: Repair Procedures

X-Axis procedures

If you are experiencing variable frame gap or shifting of the paper in
the Y direction this may indicate that the motor or driveshaft pulley
setscrews have loosened or that the belt tension is too low. Using a
1/16-in Hex wrench, tighten the 2 setscrews per pulley. Make sure
that the motor pulley has one setscrew tightened onto the flat area
of the motor shaft. The belt tension can be adjusted by loosening the
3x motor screws, pushing the motor pulley to adjust belt tension and
then retightening the screws.