Multi-Function Display (Onboard Computer); Digital Clock - Skoda Rapid Owner's Manual

Note
Never reset the display between service intervals, as this will result in the incor-
■
rect display.
Information is retained in the Service Interval Display even after the vehicle bat-
■
tery is disconnected.
If the instrument cluster is exchanged after a repair, the correct values must be
■
entered in the counter for the Service Interval Display. This work is carried out by
a specialist garage.
After resetting the display with flexible service intervals, the displayed data is
■
the same as that for a vehicle with fixed service intervals. We therefore recom-
mend that the Service Interval Display is only reset by a ŠKODA Service Partner,
who will reset the display with a vehicle system tester.
Please refer to the Service Plan for detailed information about the service inter-
■
vals.

Digital clock

ä
First read and observe the introductory information and safety warn-
ings on page 8.
Use buttons and » Fig. 2 » page 8
5 6
Select the display that you wish to change with the button
change with the button .
6
On vehicles that are fitted with the information display, it is also possible to set
the clock in the menu Time » page
Recommended gear
to set the clock.
and carry out the
5
15.
Fig. 3
Recommended gear
ä
First read and observe the introductory information and safety warn-
ings on page 8.
The currently engaged gear
B
In order to minimise the fuel consumption, a recommendation for shifting into an-
other gear is indicated in the display.
If the control unit recognises that it is beneficial to change gear, an arrow
shown in the display. The arrow points up or down, depending on whether you
should shift into a higher or lower gear.
At the same time, the recommended gear is indicated instead of the currently en-
gaged gear .
B
CAUTION
Ð
The driver is always responsible for selecting the correct gear in different driving
situations, such as overtaking.

Multi-function display (onboard computer)

ä
Introduction
This chapter contains information on the following subjects:
Memory
Operation
Ð
Multi-function display details
Warning against excessive speeds
The multi-function display can only be operated when the ignition is switched on.
After the ignition is switched on, the function displayed is the one which you last
selected before switching off the ignition.
The multi-function display is shown in the display
In vehicles with an information display
some of the information.
is shown in the instrument cluster display
» Fig. 4 » page 12.
» page 14, there is an option to fade out
Instruments and Indicator Lights
» Fig. 3.
is
A
Ð
12
12
13
14
£
11