Skoda Rapid Owner's Manual page 34

CAUTION
Keep the windows clean to ensure the correct functionality of the electric win-
■
dows.
In the event that the windows are frozen, first of all eliminate the
■
ice » page 119, De-icing windows and exterior mirrors and only then operate the
power windows otherwise the power window mechanism could be damaged.
When leaving the locked vehicle make sure that the windows are closed at all
■
times.
Note
When driving always use the existing heating, air conditioning and ventilation
■
system for ventilating the interior of the vehicle. If the windows are opened, dust
as well as other dirt can get into the vehicle and in addition the wind noise is
more at certain speeds.
At high speeds, you should keep the windows closed to prevent unnecessarily
■
high fuel consumption.
Buttons in the driver's door and the rear doors
Fig. 17 Buttons on the driver's door/in the rear doors
ä
First read and observe the introductory information and safety warn-
ings on page 31.
The power windows operate only when ignition is switched on.
Opening
›
A window is opened by pressing lightly on the respective button in the door.
The opening process stops when one releases the button.
32
Using the system
›
Additionally, the driver's window can be opened automatically (fully open) by
pressing the button to the stop. Renewed pressing of the button causes the
window to stop immediately.
Closing
›
A window is closed through pulling lightly on the respective button in the door.
The closing process stops when one releases the button.
Buttons for the power windows in the armrest for the driver
Button for the power window in the driver's door
A
Button for the power window in the front passenger's door
B
Safety switch
S
Safety pushbutton
The buttons for power windows in the rear doors can be deactivated by pressing
the safety pushbutton » Fig.
S
doors are activated again by pressing the safety pushbutton
Ð
If the buttons for the rear doors are deactivated, the indicator light  in the safe-
ty switch lights up.
S
Note
The window lift mechanism is equipped with protection against overheating. Re-
peated opening and closing of the window can cause this mechanism to over-
heat. If this happens, it will not be possible to operate the window for a short
time. You will be able to operate the window again as soon as the overheating
protection has cooled down.
17. The buttons for the power windows in rear
again.
S
Ð