Auto Check Control; Warning Lights - Skoda Rapid Owner's Manual

Factory Setting
After selecting the menu Factory setting the factory setting of the information
display is restored.
Door, luggage compartment door and bonnet ajar warning
ä
First read and observe the introductory information and safety warn-
ings on page 14.
If at least one door is open, or the luggage compartment or bonnet is open, the
information display indicates the relevant open door or luggage compartment/
bonnet.
An acoustic signal also sounds if the vehicle is travelling at more than 6 km/h.

Auto Check Control

ä
First read and observe the introductory information and safety warn-
ings on page 14.
Vehicle condition
Certain functions and conditions of individual vehicle systems are checked contin-
uously when the ignition is switched on and also while driving.
Some error messages and other information are displayed in the information dis-
play. The messages are displayed at the same time as the symbols in the informa-
tion display or the indicator lights in the instrument cluster
If there is at least one error message, the menu point Vehicle status is displayed
in the menu. After selecting this menu, the first of the error messages is dis-
played. Several error messages are shown on the display under the message e.g.
1/3. This indicates that the first of a total of three error messages is being dis-
played.
Warning symbols

Engine oil pressure too low
Clutches of the automatic gearbox are too

hot
16
Using the system

Ð

Clutches of the automatic gearbox are too hot
A symbol
clutches of the automatic gearbox is too high.
The following is displayed in the information display:
Gearbox overheated. Stop! Owner's man.!
Stop the vehicle, switch off the engine, and wait until the symbol
risk of gearbox damage! You can continue your journey as soon as the symbol dis-
Ð
appears.
Problem with the engine oil pressure
If the symbol
checked immediately by a specialist garage. The information about the maximum
permissible engine speed is displayed together with this symbol.
WARNING
If you have to stop for technical reasons, then park the vehicle at a safe dis-
tance from the traffic, switch off the engine and activate the hazard warning
light system
» page 17.
Note
If warning messages are shown in the information display, you need to confirm
■
these messages with the button
menu.
As long as the operational faults are not rectified, the symbols are always indi-
■
cated again. After they are displayed for the first time, the symbols continue to be
indicated without any extra messages for the driver.
» page 19
» page 16
Check engine oil level,
engine oil sensor faulty
Problem with the engine oil pressure
in the information display indicates that the temperature of the


is shown in the information display, you must have your vehicle

» page 36.
» Fig. 6 » page 15
B
» page 19
» page 16

disappears -

in order to call up the main
Ð