Multi-Function Display (Onboard Computer) - Skoda Rapid 2013 Owner's Manual

›
Press the button in the instrument cluster repeatedly until the wrench sym-

bol  appears.
An overdue service is indicated by a minus sign in front of the mileage or number-
of-days indication.
Resetting service interval display
If the service was not carried out by a ŠKODA Partner, the display can be reset as
follows:
›
Switch off the ignition.
›
Press and hold the button.
0.0 / SET
›
Switch the ignition on again.
›
Release the button and press the
0.0 / SET
onds.
Do not reset the service display between service intervals, as this will result in in-
correct displays.
Notice
The service message will extinguish after a few seconds with the engine running.

Multi-function display (onboard computer)


Introduction
This chapter contains information on the following subjects:
Memory
Operation
Multi-function display details
A specialist garage may program or modify additional functions depending on the
vehicle equipment. ŠKODA recommends a ŠKODA Partner for this purpose.
The multi-function display can only be operated when the ignition is switched on.
After the ignition is switched on, the function displayed is the one which you last
selected before switching off the ignition.
The multi-function display is shown in the display.
In vehicles with an information display , there is an option to fade out some of the
information.
button within approx. 20 sec-

10
10
WARNING
Concentrate fully at all times on your driving! As the driver you are fully re-
■
sponsible for road safety.
Do not only rely upon the information given on the outside temperature dis-
■
play that there is no ice on the road. Even at temperatures around +4 °C, black
ice may still be on the road surface – warning, drive with care!
Notice
In certain national versions the displays appear in the Imperial system of meas-
■
ures.
If the display of the second speed is activated in mph, the current speed is not
■
indicated in km/h on the display.
Memory

First read and observe the introductory information and safety warn-

ings on page 9.
The multi-function display is equipped with two automatic memories. The selec-
ted memory is shown in the Display.
The data of the single-trip memory (memory 1) is shown if a 1 appears in the dis-
play. A 2 shown in the display means that data relates to the total distance mem-
ory (memory 2).
Button » fig. 3 on page 10 is used to switch over the memory.
A
9
Single-trip memory (memory 1)
The single-trip memory collates the driving information from the moment the ig-
nition is switched on until it is switched off. New data will also flow into the cal-
culation of the current driving information if the trip is continued within 2 hours
after switching off the ignition. If the trip is interrupted for more than 2 hours,
the memory is automatically erased.
Total-trip memory (memory 2)
The total-trip memory gathers data from any number of individual journeys up to
a total of 19 hours and 59 minutes driving or 1 999 kilometres driven, and on vehi-
cles which are fitted with an information display up to a total of 99 hours and
59 minutes driving or 9 999 kilometres driven. The memory is deleted when ei-
ther of these limits is reached and the calculation starts all over again.
Instruments and Indicator Lights


9