Headlamp Range Adjustment; Turn Signal And Main Beam Lever - Skoda Rapid Owner's Manual

Headlamp range adjustment

ä
First read and observe the introductory information and safety warn-
ings on page 33.
›
Turn the control dial » Fig. 20 to the desired width of illumination.
Settings
The positions correspond approximately to the following car load.
Front seats occupied, luggage compartment empty.
-
All seats occupied, luggage compartment empty.
1
All seats occupied, luggage compartment laden.
2
Driver seat occupied, luggage compartment laden.
3
CAUTION
Always adjust the headlight range adjustment in such a way that:
it does not dazzle other road users, especially oncoming traffic;
■
and the range is sufficient for safe driving.
■
Note
We recommend you adjust the headlight beam when the low beam is switched
on.
Fig. 20
Dashboard: Lights and Visibility

Turn signal and main beam lever

ä
First read and observe the introductory information and safety warn-
ings on page 33.
The parking light and headlight flasher are also operated with the turn signal and
main beam lever.
Right and left turn signal light
 
›
Push the lever » Fig. 21 upwards
›
If you only wish to flash three times (the "convenience turn signal"), briefly
push the lever to the upper or lower pressure point and release again.
›
Turn signal for changing lanes - to only flash briefly, move the lever up or down
to the pressure point and hold it in this position.
Main beam

›
Switch on the low beam » page
›
Press the lever » Fig. 21 in the direction of arrow
›
The main beam is switched off by pulling the lever into the initial position in the
direction of arrow .
D
Headlight flasher

›
Pull the lever » Fig. 21 towards the steering wheel (spring-tensioned position)
in the direction of the arrow
Parking light 
Ð
Description of the operation » page 36
CAUTION
Only use the main beam or the headlight flasher if other road users will not be
dazzled.
Fig. 21
Turn signal and main beam lever
or downwards .
A B
33.
C .
.
D
Lights and Visibility
£
35