Auto-Setup; Satellite Receiver - Panasonic Diga DMR-EZ45VEBS Operating Instructions Manual

Connecting to a television and satellite receiver

Auto-Setup

Auto-Setup
No stations found !
Please check aerial connection
Restart Auto-Setup ?
Yes
SELECT
ENTER
RETURN
If you receive your television programme via a satellite receiver (digital/analogue),
connect your DVD Recorder as shown in connection type B.
If your television supports Q Link, use a fully wired 21-pin Scart cable to connect it
to the TV.
The analogue stations automatically downloaded through [Download from TV].
If your television supports RGB, set the AV1 Output to [RGB 1] or [RGB 2]
in the Setup menu.
1
Connect the aerial to the RF IN (aerial input) and/or the dish (satellite) to the
LNB IN of the external unit.
2
Connect the RF OUT (aerial output) of the external unit with the RF IN (aerial
input) of the DVD Recorder.
3
Connect the RF OUT (aerial output) of the DVD Recorder with the RF IN (aerial
input) of the television unit.
4
Connect the AV1 terminal (21-pin Scart terminal) of the DVD Recorder with the
Scart input of the television unit.
5
Connect the external unit with a 21-pin Scart cable to the AV2 terminal of the
DVD Recorder.
6
Connect the DVD Recorder, the TV and the external unit to the household mains
socket.
Auto-Setup with connected Satellite Receiver and aerial
After completing the above connections, proceed to the Auto-Setup.
Auto-Setup with connected Satellite Receiver
Turn on the television and select the AV input that this unit is connected to.
Switch on the external unit and DVD Recorder.
[Auto-Setup] follows automatically and if it ends with the note: [No stations found !].
Select [No] with
You can complete the Owner ID now. To skip this step and do it later,
press the RETURN button.
No
The TV Guide does not show any information if you have connected
the unit to a satellite receiver only.
The date and time are not set automatically. Set them manually.
An incorrect date or time affects the programmed recording of television programmes
(note summer and winter time).
Your DVD Recorder is now ready to use.
Switch the DVD Recorder to AV2 with CH .
You see the television picture from the external unit.
View / record satellite programmes
Press INPUT SELECT to select the input channel AV2 or put this unit in
standby mode.
To record satellite programmes refer to "VIDEO Plus+ codes for satellite
receivers".
and confirm with ENTER.
B
64
11
67
66
52
13