Level 2 Service Manual
Removing and Replacing the Flip Display Lens
6809485A78-O
1.
Remove the battery cover, battery, antenna, keypad bezel, speaker cover,
keyboard stiffener, flip assembly, and transceiver board as described in the
procedures.
2.
Insert a small knife blade into the seam between the main lens and the flip
sleeve edge and pry up the main lens edge (see Figure 20).
Figure 20. Removing the Flip Display Lens
3.
Insert the flat end of the disassembly tool into the gap created by the knife
blade and separate the display lens from the flip assembly.
4.
To replace, align the display lens to the flip assembly. Expose the display lens
adhesive. Carefully press the display lens into position on the flip assembly.
5.
Replace the transceiver board and flip assembly, keypad stiffener, speaker
cover, keypad bezel, antenna, battery, and battery cover as described in the
procedures.
June 07, 2004
Disassembly
flip display lens
knife blade
flip assembly
040370o
39