Disassembly
Removing and Replacing the Flip Assembly Cover
24
1.
Remove the battery cover, battery, USIM, memory card, rear housing, and
transceiver board assembly as described in the procedures.
2.
Remove the 4 flip assembly screw caps.
3.
Use the T-5 driver to remove the 4 screws from the flip assembly (see Figure
10). Retain the screws for re-assembly.
Figure 10. Removing the Flip Assembly Screws
4.
Before removing the flip cover, note the locations of the smart buttons on the
sides of the flip assembly.
5.
Use the disassembly tool to gently pry off the flip cover (see Figure 11).
Disassembly Tool
Figure 11. Separating the Flip Assembly Cover
May 09, 2007
Screws
Screws
Flip Assembly Cover
V3xx
061431o
040722o
6809505A64-A