Mitsubishi 4G1 Service Manual page 505

OIL PUMP DRIVEN GEAR / OIL PUMP DRIVE GEAR
INSTALLATION
(1) Apply' engine oil amply to the gears and line up the
alignment marks.
SEALANT APPLICATION TO OIL PRESSURE GAUGE
UNIT
switch using the special tool.
Specified sealant: 3M ATD Part No. 8660 or equivalent
Caution
2. Avoid an overtightening.
SEALANT APPLICATION TO OIL PRESSURE
SWITCH
switch using the special tool.
Specified sealant:
Caution
1. Keep the end of threaded portion clear of sealant.
2. Avoid an over-tightening.
RIGHT SILENT SHAFT REAR BEARING
INSTALLATION
(1) Apply engine oil to the outer surface of bearing.
(2) Using special tools, install right rear bearing. Make sure that
oil hole of bearing is aligned with oil hole of cylinder block.
vision
I
11 F-99