Mitsubishi 4G1 Service Manual page 156

11 C-32
Center of yx
tensioner -
TIMING BELT "B" 'INSTALLATION
(1) Align timing marks on the crankshaft sprocket "B" and
silent shaft sprocket with the marks on the front case
respectively.
(2) Install the timing belt "B" on the crankshaft sprocket "B"
and silent shaft sprocket. There should be no slack on the
tension side.
(3) Make sure that the relationship between the tensioner
pulley center and the bolt center is as shown in the
illustration.
(4) Move the tensioner "B" in the direction of arrow while
lifting with a finger to give a sufficient tension to the tension
side of timing belt. In this condition, tighten the bolt to
secure tensioner "B". When the bolt is tightened, use care
to prevent shaft from turning together. If the shaft is turned
together, the belt will be over-tensioned.
(5) Check to ensure that the timing marks on the sprockets and
front case are in alignment.
(6) Press with index finger the center of span on the tension
side of timing belt "B". The belt must deflect 5 - 7 mm (.20
CRANKSHAFT BOLT INSTALLATION
(1) Using the special tool, hold the drive plate or flywheel.
(2) Install the crankshaft bolt.
TSB Revision