Mitsubishi 4G1 Service Manual page 108

11 B-46
General
REMOVAL SERVICE POINTS
General
OIL PAN REMOVAL
(1) Knock the special tool deeply between the oil pan and the
cylinder block.
(2) Hitting the side of the special tool, slide the special tool
along the oil pan to remove it.
insert a Phillips screwdriver [shank diameter 8 mm (32 in.)]
into the plug hole on the left side of the cylinder block to
block the silent shaft.
(1) The front case may be sticking to the cylinder block. In such
a case, insert a screwdriver into the slot shown in the
illustration and pry up. Never attempt to pry at any other
positions where flange is thinner. !Also avoid applying
impact to the front case for removal.
SILENT SHAFT FRONT BEARING REMOVAL
cylinder block.
SILENT SHAFT REAR BEARING REMOVAL
cylinder block.
TSB Revision
,