Brother MFC9100C Service Manual page 160

Selector
No.
1
| Not used.
7
Erasure of message stored in the
8
memory after the message
transfer
l l Selector 8: Erasure of message stored in the memory after the message transfer
Setting this selector to "0" will erase the message recorded in the memory after the document
retrieval feature transfers the message.
Selector
No.
1 ECM* in sending
2 ECM* in receiving
3 Not used.
4 Copy resolution
5
Acceptable TCF bit error rate (%)
|
(Only at 4800 bps)
8
NOTE: Selectors 5 through 8 are applicable to the Chinese, Taiwanese and Asian versions only.
Selector 4: Copy resolution
l l
This selector determines whether resolution for multi-copy should be Fine or Superfine.
Selectors 5 through 8: Acceptable TCF bit error rate (%)
l l
Setting two or more selectors to "1" produces addition of percent assigned to each selector. If you
set selectors 7 and 8 to "1," the acceptable TCF bit error rate will be 3%.
WSW21
(TAD setting 1)
Function
WSW22
(ECM and copy resolution setting)
Function
V - 33
Setting and Specifications
0: Yes 1: No
Setting and Specifications
0: ON 1: OFF
0: ON 1: OFF
0: Fine 1: Superfine
0: 0% 1: 8%
0: 0% 1: 4%
0: 0% 1: 2%
0: 0% 1: 1%
* ECM: Error correction mode