Brother MFC9100C Service Manual page 102

1.28 Carriage Rail, Carriage ASSY,
and Carriage Motor
(1) Take off the idle pulley stopper by removing the screw.
(2) While pushing the idle pulley holder to the right (in the direction of arrow
drive belt from the carriage motor gear (arrow
idle pulley holder (arrow
On the idle pulley holder are the idle pulley, idle pulley shaft, and spring as shown on the next
page.
Caution
ƒ
) and take off the idle pulley holder from the main chassis.
IV - 61
Once the components given in this
subsection are removed, it is recommended
that the gap adjustment jig be used for
accurate head-platen gap. Refer to Section
3, "ADJUSTMENT" in this chapter.
‚
). Then remove the CR drive belt from the
•
), remove the CR