Connect The Interface And Power Cables; Cabinet Models - IBM 6400-D Generation II Series Setup Manual

Connect The Interface And Power Cables

Cabinet Models

<1>
<4>
<5>
1. Verify that the voltage source at the printer site conforms to the
requirements specified on page 19. Make sure that the printer power
switch is set to Off. See Figure 18.
2. Open the cabinet front door, remove and open the cardboard box
containing the power cord, printer ribbon, and operator panel overlay
label. Refer to Appendix A, "Printer Specifications," for recommended
cables. Documentation is stored in a pouch container on the left interior
side of the cabinet.
3. Referring to Figure 18 through Figure 23, connect the customer-supplied
interface cable from the host computer to the appropriate printer interface
connector.
4. Thread the power cable connector up through the notch in the lower right
back corner of the cabinet (see Figure 18). Plug the power cord into the
printer AC power connector, then into the AC power outlet.
Connect The Interface And Power Cables
DANGER:
Before powering on the printer ensure the printer is plugged
into an appropriate power source. Refer to Chapter 2 of the
Setup Guide for information on the proper source.
Do not connect or disconnect any communication port,
teleport, attachment connector, or power cord during an
electrical storm.
Power off the printer and disconnect the power cord before
connecting or disconnecting any communication port,
teleport, or attachment cable connector.
Cabinet Models
37