Table of Contents
Advertisement
Fault
Message
082 POWER 8.5 CHECK*
SEE USERS GUIDE
083 INTAKE FAN CHECK*
SEE USERS GUIDE
084 POWER 48V CHECK*
SEE USERS GUIDE
085 CONTROL VOLT CHECK
SEE USERS GUIDE
086 CONTROL 15V CHECK
SEE USERS GUIDE
087 PLATEN OPEN TIMEOUT
CLOSE PLATEN
088 CONTROL 23.5V CHECK
SEE USERS GUIDE
089 RIBBON STALL
CHECK RIBBON
090 SHUTTLE COVER OPEN
CLOSE SHUTTLE COVER
092 RBN DRVR CIRCUIT*
SEE USERS GUIDE
101 UPPER DRIVER SHORT
102 LOWER DRIVER SHORT*
SEE USERS GUIDE
107 COIL HOT
110 STACK OVERFLOW*
SEE USERS GUIDE
111 STACK UNDERFLOW
SEE USERS GUIDE
112 UNDEFINED OPCODE*
SEE USERS GUIDE
Operator
Explanation
Correctable?
No
Internal power failure.
Yes
Sensors cannot detect
current in fan circuit.
No
Internal power failure.
No
Controller voltage
failure.
No
Controller voltage
failure.
Yes
Forms thickness lever
has been open for at
least one minute.
No
Controller voltage
failure.
Yes
No ribbon movement.
No
Shuttle cover is
missing, damaged, or
not correctly installed.
No
Controller board does
not detect ribbon drive
motor.
No
Hammer driver circuits
on the controller board
shorted to ground.
No
Circuit(s) on the
hammer bank or in the
hammer bank power
cable shorted to
ground.
No
One or more hammer
coils are overheating.
No
Fatal firmware error on
the controller board.
No
Fatal firmware error on
the controller board.
No
Fatal firmware error on
the controller board.
Fault Correction Procedure
Solution
Contact IBM service.
Contact IBM service.
Contact IBM service.
Contact IBM service.
Contact IBM service.
Close forms thickness
lever.
Contact IBM service.
Make sure the ribbon is
not twisted and the
forms thickness lever is
set to match thickness
of media being used. If
fault reoccurs, contact
IBM service.
Contact IBM service.
Contact IBM service.
Contact IBM service.
Contact IBM service.
Stop printing and allow
the printer to cool for
five minutes. If the fault
reoccurs, contact IBM
service.
Contact IBM service.
Contact IBM service.
Contact IBM service.
141
Advertisement
Table of Contents
