Ypbpr Signals (Component Video) - Runco Video Xtreme VX-40d Owner's Operating Manual

NOTES: 1) If for some reason the projector fails to recognize a signal as an RGB signal,
specify this Color Space option within the Image Settings menu. See 3.5 Adjusting
the Image. 2) To connect YPbPr signals–such as from DVDs or analog HDTV sources–
to INPUT 1, use the red, green and blue BNCs as described in YPbPr Signals (below).
Connect a YPbPr signal (component video) to INPUT 1 or INPUT 2 as shown in Figure
2.11.
NOTES: 1) If, for some reason, the projector fails to recognize a YPbPr signal, specify this
Color Space option within the Image Settings menu. See 3.5, Adjusting the Image.
2) Do not connect digital component signals (known as YCbCr) to INPUT 1. Install an
appropriate optional module in INPUT 5 or INPUT 6 for this.
Figure 2.10 Connecting RGB and Sync
Figure 2.11 Connecting YPbPr sources
Fron DHD
Controller
21
Section 2: Installation and Setup
YPbPr signals
(COMPONENT VIDEO)